Arista DCS-7804 - Connecting Line Card Modules and Cables

Cabling the Modular Switch
4.9 Connecting Line Card Modules and Cables
Install required SFP, SFP+, QSFP+, QSFP100, OSFP, and QSFP-DD optic modules in line card
module ports (Figure 22: SFP or SFP+ Ports).
Figure 22: SFP or SFP+ Ports
Connect cables as required to line card module ports. Supervisor and line card module ejectors on the
front of the chassis assist with cable management.
CAUTION: Excessive bending can damage interface cables, especially optical cables.
Flexion excessive peut endommager les câbles d'interface, en particulier les câbles optiques.
Note:
You must ensure that any open slots for modules, power supplies, etc. are covered by
the appropriate “blank” plates. Check with your local Arista Networks representative if you
have questions.
35