Maintenance and Field Replacement
3. Slide supervisor module into slot.
4. Lock the supervisor module in place using the tool supplied (Front Panel).
5. Verify that the module is operating normally (Table 10: Supervisor Status LED States).
F.5.3 Removing Supervisor Module Blank
The supervisor module blank has plastic latches.
1. Put on a grounded, anti-static ESD strap.
2. Grip the plastic handles to release the latch and remove the blank from the supervisor module slot
you are going to populate.
You may want to save the blank for future use as needed. The blank is needed for the switch to
operate normally if a supervisor module slot is not populated.
F.6 Line Cards
The line cards are hot-swappable. They are accessible from the front of the switch. You must take into
account that the line card you are inserting is compatible with the switch and the line card that you are
replacing. Use the following procedure to remove and replace a line card. If you are adding a new line
card, remove the blank from the line card slot and install the new line card. For the line card locations
on your switch, refer to Front Panel.
F.6.1 Removing Line Card
Perform the following steps to remove a line card:
1. Put on a grounded, anti-static ESD strap.
2. Use the tools supplied (Front Panel) simultaneously on each end of the line card.
3. Pull the line card out gently once released.
4. Slide line card out of the slot.
F.6.2 Installing Line Card
You must make space for installing the linecard by removing an existing one (Removing Line Card) or
removing a blank (Removing Line Card Blank) from a linecard slot available on the switch.
F.6.3
1. Put on a grounded, anti-static ESD strap.
2. Unpack the line card to be installed.
3. Slide the line card into the slot.
4. Use the tools supplied (Front Panel) simultaneously on each end of the line card to lock it in
place.
5. Verify that the line card is operating normally (Line Card Module Indicators).
Removing Line Card Blank
Perform the following steps to remove line card blank:
1. Put on a grounded, anti-static ESD strap.
2. Grip the plastic handles to release the latch and remove the blank from the line card slot you are
going to populate.
The line card blank has plastic latches. You may want to save the blank for future use as needed.
The blank is needed for the switch to operate normally if a line card slot is not populated.
69
To Next Page
Loading...