ARM Cortex-M3 DesignStart - Embedded Trace Macrocell Interface

3.7 Embedded Trace Macrocell interface
If you want to use the MPS2+ platform to capture Embedded Trace Macrocell (ETM) trace, then you are
required to use a suitable debug adapter, such as DSTREAM or ULINKpro. This can be connected using
the 20-pin debug connector.
Serial Wire trace (instrumentation trace only) can be captured using a DSTREAM, ULINKpro-D,
ULINKplus, or ULINK2 debug adapter.
3 FPGA platform overview
3.7 Embedded Trace Macrocell interface
ARM 100896_0000_00_en Copyright © 2017 ARM Limited or its affiliates. All rights reserved. 3-31
Non-Confidential