A R R I S
Getting Battery Ethernet
Safety Started Installation Installation Configuration Usage Troubleshooting Glossary
Configuring Your Ethernet Connection
If your computer is equipped with a LAN card providing an Ethernet connection,
you may have to configure your computer's TCP/IP settings. The steps that follow
will guide you through setting your computer's TCP/IP settings to work with the
Telephony Gateway.
Requirements
Make sure you have the following before attempting to configure your Ethernet
connection:
Computer with:
— one of: Windows XP, Windows Vista, Windows 7, Windows 8, or MacOS
X
— Ethernet interface
Ethernet cable (supplied)
IP address, subnet, gateway, and DNS information for installations not
using DHCP
How to use this chapter
The following list shows the procedures for modifying the TCP/IP settings on the
computer. The procedure is slightly different depending on the operating system
that you are using. Please ensure you are using the correct steps for the
operating system on your computer. Follow the links below for instructions to
configure your Ethernet connection on your operating system.
TCP/IP Configuration for Windows XP
TCP/IP Configuration for Windows 7
TCP/IP Configuration for MacOS X
Note: For Windows 8 and Windows Vista, use the Windows 7 procedure.
They are very similar.
To Next Page
Loading...
