Artesian Spas PLATINUM ELITE - Circulation Pump Modes; Filtration and Ozone

SPA BEHAVIOR
34
minute every 30 minutes to detect the spa temperature (polling) and then
to heat to the set temperature if needed. When the low-speed turns on
automatically, it cannot be deactivated from the panel, however the high
speed may be started.
CIRCULATION PUMP MODES
If the system is equipped with a circ pump, it will be congured to work in
one of three different ways:
1, The circ pump operates continuously (24 hours) with the exception of
turning off for 30 minutes at a time when the water temperature reaches
3°F (1.5°C) above the set temperature (most likely to happen in very hot
climates).
2, The circ pump stays on continuously, regardless of water temperature.
3, A programmable circ pump will come on when the system is check-
ing temperature (polling), during lter cycles, during freeze conditions, or
when another pump is on. The specic Circulation Mode that is used has
been determined by the Manufacturer and cannot be changed in the eld.
Other device options may be available, like Blower, Light, Mister, etc.
FILTRATION AND OZONE
On non-circ systems, Pump 1 low and the ozone generator will run during
ltration. On circ systems, the ozone will generally run with the circ pump,
but can be limited to ltration cycles. (On some circs systems, Pump 1 low
will run along with the circ Pump during ltration.)
The system is factory-programmed with one lter cycle that will run in the
evening (assuming the time-of-day is properly set) when energy rates are
often lower. The lter time and duration are programmable.
A second lter cycle can be enabled as needed.
At the start of each lter cycle, the water devices like blower, mister device
(if these exist) and other pumps will run briey to purge the plumbing to
maintain good water quality.