ADJUSTING FILTRATION
38
THE MEANING OF FILTER CYCLES
1. The heating pump always runs during the lter cycle*
2. In Rest Mode, heating only occurs during the lter cycle
3. Purges happen at the start of each lter cycle
* For example, if your spa is set up for 24/hour circulation except for shut-
ting off when the water temperature is 3˚F/1.3˚C above the set tempera-
ture, that shutoff does not occur during lter cycles.
AUXILIARY PANELS
SPECIFIC BUTTONS FOR SPECIFIC DEVICES
If the spa has an Auxiliary Panel(s) installed, pressing buttons on that pan-
el will activate the device indicated for that button.
These dedicated buttons will operate just like the Spa Screen buttons and
the equipment will behave in the same manner with each button press.
RESTRICTING OPERATION
The control can be restricted to prevent unwanted use or temperature
adjustments. Locking the Panel prevents the controller from being used,
but all automatic functions are still active.
Locking the Settings allows Jets and other features to be used, but the Set
Temperature and other programmed settings cannot be adjusted. Settings
Lock allows access to a reduced selection of menu items. These include
Filter Cycles, Invert, Information and Fault Log. They can be seen, but not
changed or edited.
Heat
Lock
Time
Filter
Reminders
Light Cycle
Settings Lock
Settings
Unlocked
Panel
Locked
To Next Page
Loading...
