37
ADJUSTING FILTRATION
FILTER CYLCE 2 OPTIONAL FILTRATION
Filter Cycle 2 is OFF by default.
Viewing Filter 1 while Filter 2 is OFF: Viewing Filter 1 while Filter 2 is ON:
Press “1” to view Filter 1. Press “2” once to view Filter 2.
Press “2” again to turn Filter 2 ON or OFF.
When Filter Cycle 2 is ON, it can be adjusted in the same manner as
Filter Cycle 1.
It is possible to overlap Filter Cycle 1 and Filter Cycle 2, which will short-
en overall ltration by the overlap amount.
CIRCULATION PUMP MODES
Some spas may be manufactured with Circ Pump settings that allow
programming ltration cycle duration. Some circ Modes are pre-pro-
grammed to operate 24 hours a day and are not programmable. Refer
to the spa manufacturer’s documentation for any Circ Mode details.
PURGE CYCLES
In order to maintain sanitary conditions, as well as protect against freez-
ing, secondary water devices will purge water from their respective
plumbing by running briey at the beginning of each lter cycle. (Some
systems will run a certain number of purge cycles per day, independent
of the number of lter cycles per day. In this case, the purge cycles may
not coincide with the start of the lter cycle.)
If the Filter Cycle 1 duration is set for 24 hours, enabling Filter Cycle 2
will initiate a purge when Filter Cycle 2 is programmed to begin.
Filtration Filtration
Start
End
Duration
9:15 pm
9:16 pm
3 Hr 00 Min
Start
End
Duration
9:15 pm
9:16 pm
3 Hr 00 Min
To Next Page
Loading...
