DEMO MODE
Demo Mode is not always enabled, so it may not appear. This is designed
to operate several devices in a sequence in order to demonstrate the vari-
ous features of a particular hot tub.
FAULT LOG
The Fault Log is a record of the last 24 faults that can be reviewed by a
service tech. Use the Up and Down buttons to view each of the Faults.
When Priming Mode shows in the Fault Log, it is not a fault. Rather, it is
used to keep track of spa restarts.
GFCI TEST (FEATURE NOT AVAILABLE ON CE RATED SYSTEMS)
Your systems may have GFCI congured in one of three ways:
1. GFCI test is not enabled
2. Manual GFCI test is enabled but automatic GFCI test is not enabled
3. Both manual and automatic GFCI tests are enabled. The automatic
test will happen within 7 days of the spa being installed and if success-
ful will not repeat. (If the automatic test fails it will repeat after the spa is
restarted.)
GFCI Test will not appear on the screen if it is not enabled. This screen
allows the GFCI to be tested manually from the panel and can be used to
reset the automatic test feature.
UTILITIES SCREEN
44
To Next Page
Loading...
