Fault messages and fault clearance
58 182099015-V01-10.Juni2013-GA-MCL31-THAI
Possible malfunctions
Explanation/corrective action
Check that the power lead has been connected to a power outlet.
Is the power switch set to position ‘I’?
Check that the Laser emergency Stop switch is released.
Check the line fuses of the domestic power supply system.
Function keys of
the display do not
react (or only
sporadically)
Faulty calibration of the touchscreen
The touchscreen must be calibrated by an authorized service engineer.
Therefore, inform your vendor or the Engineering Department of
Asclepion Laser Technologies GmbH directly (see chapter ‘Customer
service’).
No laser emission
with the foot
switch pressed
Check that the foot switch lead is properly connected.
The device is in STANDBY mode. Press the READY key to switch to the
READY mode.
To Next Page
Loading...