Fault messages and fault clearance
182099015-V01-10.Juni2013-GA-MCL31-THAI 57
9.2 Fault messages and fault clearance
The MCL 31 Dermablate is provided with alarm systems. If they are triggered, the system will
switch to safe mode and stop any emission of laser radiation. Attempt to remove the fault
yourself, following the instructions given in the table below. If the error persists, contact Asclepion
Laser Technologies GmbH or a service partner explicitly authorized by Asclepion Laser
Technologies GmbH.
Before you contact the Engineering Department of Asclepion Laser Technologies GmbH,
please make a note of the fault message and the error code displayed.
To Next Page
Loading...