TD 92674EN
29 April 2015 / Ver. I
Configuration Manual
Ascom d81 DECT Handset
42
5. Handset Configuration
• Vibrator for call waiting
Determines whether or not the handset vibrates when another call is received before the
user has finished an ongoing call. If set to "Yes", the handset vibrates during the ongoing
call.
NOTE: To enable the Vibrator for call waiting function the Vibrating alert parameter must
be enabled, and both
Switch call and Call waiting must be configured. For more
information on how to configure
Switch call and Call waiting, see 5.9 In Call Menu on
page 23.
• Vibrator for message during call
Determines if the handset vibrates when receiving messages during an ongoing call.
NOTE: To enable the
Vibrator for message during call function the Vibrating alert
parameter must be enabled.
Settings > Messaging
•Text size
Size of the message text when viewing and writing messages.
• Time to Read (TTR)
Determines if the user needs to close a message manually, or if the message is closed
automatically when TTR expires. Regardless how a message is closed, it is removed from
the message queue and stored in the Messaging Inbox. TTR starts when a message is
displayed and keep running also when the message is placed in the messaging queue. If
a user presses any key when a message is displayed, the TTR is reset. See also
5.31.2
Examples of TTR/TTP Settings.
• Time to Prioritize (TTP)
Determines how long messages keep their priority status. The TTP starts when a
message is displayed. If a user presses any key when a message is displayed, the TTP is
reset. If receiving a message with higher priority than the displayed message, the
message with lower priority is placed in queue and its TTP is paused. When the TTP
elapsed for a message, it is put last in the queue. See also
5.31.2 Examples of TTR/TTP
Settings.
• Message List representation
Can be set to text or number.
• Repeat Message Indication
This parameter enables/disables message indications. It sets whether a message
indication is repeated until confirmed by the user or not. The current repetition rate is 7
seconds. If the message itself contains a repetition, it overrides this setting.
• IM (Interactive Messaging) Option Mode
This parameter is used for older applications and sets that three soft keys are placed
automatically, i.e. on softkeys or in an option menu (list).
To Next Page
Loading...
