TD 92674EN
29 April 2015 / Ver. I
Configuration Manual
Ascom d81 DECT Handset
43
5. Handset Configuration
• Call priority
This parameter determines:
- whether call information presented on the display during incom
ing, ongoing and
outgoing call is suppressed when viewing a message
- whether an ongoing call is disconnected when receiving a PTT invita
tion with Answer
mode set to “Automatically”.
0 = Call indication overrides all messages
and ongoing call is never disconnected
(default).
1-9 = Comparison with message priority; highest priority is shown and PTT invita
tion
with higher priority causes disconnection of ongoing call.
10 = Call indication on the display is always su
ppressed and ongoing call is always
disconnected by a PTT invitation.
The tables below show examples of priority set
tings and how they affect the handset
behaviour.
Call priority PTT invitation
(p
riority)
a
Disconnection of ongoing call?
0 1 No, since this call priority setting overrides all
PTT invitations regardles
s of priority.
6 6 No, an ongoing call is not disconnected when
the priority is equal.
2 1 Yes, immediately since the PTT priority is set to
1 and also is h
igher than Call priority.
3 2 Yes, after 10 seconds since the PTT priority is
higher than Call priority.
10 1 Yes, immediately since the PTT priority is set to
1 and also is h
igher than Call priority.
10 2 Yes, after 10 seconds since the PTT priority is
higher than Call priority.
Table 3. Call priority vs PTT priority
Call priority Displayed Message
(p
riority)
Call information suppressed?
0 1 No, since this call priorit
y setting overrides all
messages regardless of priority.
7 6 Yes, since the priority of the displayed
message is h
igher than the incoming call.
6 6 Yes, since the message is considered as most
im
portant when the priority is equal.
1 3 No, since the priority of the incoming call is
higher than the displayed m
essage.
10 1
Yes, the call information is always suppressed
regardless of the message priority.
Table 4. Call priority vs Message priority
a.PTT invitation received as incoming call has always priority 6, while PTT invitation received as message
can have priority 1 - 9 depending on configuration.