5200 Series Programming Instructions
5
80-9352-0022-020 Rev 2 06/23
Copyright © 2023, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole or in
part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
C. Adjust open and close settings:
Use the 5200 Series Operator Wi-Fi programming to
adjust backcheck location, latch location, and sweep
speed. (Figure 10)
NOTE: Additional programming options are available
through Wi-Fi programming only.
Refer to the following sections for additional information:
“Operator Setup via Wi-Fi” on page 6
“Adjust the Operator Settings.” on page 8
“Connections” on page 10
Continue with “Connections” on page 10
Speed/Force and Timing/Location settings
must be adjusted to meet ANSI BHMA A159.19
(American National Standard for Power Assist
and Low Energy Power Operated Doors)
requirements for opening and closing based
on door weight and width.
Setup Using Control Board (cont.):
Figure 10
To Next Page
Loading...
