POSI-TRACK 2800 & 2810
PAGE 15
ASV, INC.
Start the vehicle and allow engine to warm up
for two minutes before increasing throttle to de-
sired RPM. First time operators will want to
learn at a lower RPM (2,000 or less) until they
feel comfortable with the controls. It is also rec-
ommended that the first time operator concen-
trate on learning the drive controls before mov-
ing on to the loader or other attachment controls.
Place one hand over both drive control levers.
Push both levers forward in unison to move for-
ward, and pull both levers back in unison to
move in reverse. The further the levers are
moved, the faster the vehicle travels in either di-
rection.
To turn to the right, push the left lever farther
than the right lever (this makes the left track turn
faster than the right track). To turn to the left,
push the right lever further than the left lever.
To turn the vehicle in its own axis (counter-
rotate) push one lever forward and pull the other
in reverse.
NOTE
The engine will not start if the drive controls
are not in neutral. Loader valve will not func-
tion unless the operator is seated.
NOTE
For best performance, always put power to
both tracks when making a turn. When both
tracks are turning, the vehicle will turn easier,
which also results in less damage to the
ground.
GENERAL OPERATION
Fig. 8
Fig. 9
To Next Page
Loading...
Need help?
General
