POSI-TRACK 2800 & 2810
PAGE 32
ASV, INC.
ENGINE OIL & FILTER CHANGE
Engine oil and filter should be changed every
250 hours after the initial 100 hour break-in.
This service interval should be shortened if the
vehicle is used in extremely dusty conditions.
1. Run engine approximately 5 minutes to warm
up oil. Shut off engine.
2. Remove oil drain plug (A) beneath the en-
gine compartment and allow to drain.
3. Using a filter wrench, remove oil filter ele-
ment (B) and dispose of properly.
4. Replace with new filter element, and tighten
¾ to 1¼ turn after the filter contacts the housing.
DO NOT over tighten.
5. Install oil pan drain plug, ensure plug seal is
still in good condition.
6. Fill engine crankcase to specified level.
(6.8 quarts)
7. Run engine to check for possible leaks.
8. Stop engine for 10 minutes and recheck oil
level. Oil level should be within the crosshatch
of the dipstick.
GENERAL MAINTENANCE
Fig. 42
Fig. 43
A
B
To Next Page
Loading...
Need help?
General
