POSI-TRACK 2800 & 2810
PAGE 50
ASV, INC.
PROBLEM CAUSE REMEDY
Attachment won’t 1. Quick-coupler not plugged 1. Find and plug in
operate in all the way quick coupler
2. Faulty quick-coupler 2. Replace
3. The other auxiliary lever 3. Put lever in neutral
is engaged
4. Hoses hooked up wrong 4. Refer to hydraulic flow
diagram on page 48
5. Faulty attachment 5. Contact dealer or refer to
an attachment owners
manual
Hot oil light comes on 1. Hydraulic oil cooler is 1. Clean with compressed
plugged with debris air or pressure washer
2. Hydraulic attachment is 2. Get the right sized
undersized for the flow attachment or reduce the
and/ or pressure engine rpm until the flow
is in the correct range
(Refer to decal on vehicle)
3. One of the auxiliary hydraulic 3. Put lever in neutral
levers is engaged without an
attachment being hooked up.
4. Defective sender or light 4. Replace as needed
5. Wires to light are grounding out 5. Repair
Attachment doesn’t 1. Attachment is incorrect size 1. Get the appropriate
work properly for the flow and pressure. attachment
2. Auxiliary hydraulic pressure 2. Contact dealer
is set too low.
Loader doesn’t 1. Auxiliary hydraulic pressure 1. Contact dealer
lift proper weight is set too low
2. Weight is too far out from 2. Bring load in closer
vehicle or reduce load
3. Auxiliary lever is engaged 3. Put lever in neutral
TROUBLE SHOOTING (GENERAL)
To Next Page
Loading...
Need help?
General
