POSI-TRACK 2800 & 2810
PAGE 51
ASV, INC.
PROBLEM CAUSE REMEDY
Attachments, tracks
1. One or both auxiliary hydraulic 1. Put lever in neutral
weak on power levers are engaged
2. Hydraulic oil is still cold 2. Let oil warm up for a
few minutes
Tracks respond 1. Hydraulic oil is still cold 1. Let oil warm up for
sluggishly a few minutes
2. Low charge pressure 2. Contact Dealer
3. Low hydraulic oil 3. Add hydraulic oil
4. Hydraulic filters plugged 4. Change filters
One track won’t go 1. Brake is engaged 1. Rotate track in both
directions to take bind
off brake ram
2. Cable is disconnected on 2. Reconnect cable
lever
3. Cable is disconnected on 3. Contact dealer
pump
Track will only 1. Loosen or disconnected drive
go in one direction tube or fitting 1. Contact dealer
2. Broken drive tube inside 2. Contact dealer
hydraulic reservoir
3. Cable linkage in tank 3. Contact dealer
is broken
Track derails 1. Track is too loose 1. Tighten to proper
adjustment.
2. Bearing failure in one of 2. Replace bearing
the end tubes or out board
bearing on drive sprocket
3. Drive Sprocket miss aligned 3. Make sure tension
undercarriage frame. Adjustment bolts are in
the same adjustment holes
4. Bent idler wheel 4. Replace wheel
5. Terrain too steep or improper
driving techniques
TROUBLE SHOOTING (GENERAL)
To Next Page
Loading...
Need help?
General
