AT&T 945 - Program the Remote Code

Feature setup
Feature setup
Program the remote code
You can change the remote code (password) used to
access your phone remotely.
1. Press E to begin feature setup.
2. Press - until the screen display includes
DTAD/AA.
3. Press E. The screen display includes
ANSWERxSTATUS.
4. Press - until the screen display includes
REMOTE CODE and the current code.
5. Use the dial pad to enter a three-digit remote
code, then press - to save the new code. The
screen display includes MESSAGE LENGTH.
6. Proceed to step 5 on page 51 to set the next
feature (message length).
—OR—
Press and hold E to return to the idle
screen.

NOTE: You can exit feature setup and return to the
idle screen any time. Simply press and hold E.
50
i
ii
ii
n
nn
nn
984CIB_(Rev9)ml_24.05.06 5/24/06 8:07 PM Page 50