Feature setup
Feature setup
Turn toll saver on or off
When toll saver is turned on, the answering system picks
up incoming calls within eight seconds if there is at least
one new message. When there are no new messages, the
answering system picks up the incoming call in the time
you set as the answer delay (see Set answer delay on
page 45 for details).
1. Press E to begin feature setup.
2. Press - until the screen display includes
DTAD/AA.
3. Press E. The screen display includes
ANSWER STATUS.
4. Press - until the screen displays includes TOLL
SAVER and the current setting.
5. Press < or > to toggle between Off and On.
6. When the desired setting is shown, press - to
save your choice. The screen display includes
REMOTE CODE.
7. Proceed to step 5 on page 50 to set the next
feature (remote code).
—OR—
Press and hold E to return to the idle
screen.
NOTE: You can exit feature setup and return to the
idle screen any time. Simply press and hold E.
49
i
ii
ii
k
kk
kk
o
oo
oo
n
nn
nn
To Next Page
Loading...
Need help?
General
