Directory operation
Directory operation
Store a name and number in the directory
continued from page 77
Store a temporary tone signal in a
directory number
If you have dial pulse (rotary) service, you can store tone
signals in a directory number. When you reach the place in
the dialing sequence where you wish tone dialing to begin,
press - until the screen displays:
Press E. All digits entered after this will send tone
signals. If you want to save the number in the directory,
press - to reach DONE and then press E to save.
Store a flash in a directory number
You can store the switchhook flash needed to access some
custom-calling services in a directory number. When you
reach the place in the dialing sequence where you wish
to enter a flash, press - until the screen displays:
Press E to store the flash, then continue entering the
number. Each flash counts as one digit. If you want to save
the number in the directory, press - to reach DONE and
then press E to save.
JIMTERXNAMELLXX
555_
XXXXXXXXXXXXXXx
FLASHXNUMBERXXXx
JIMTERXNAMELLXX
555_
XXXXXXXXXXXXXXx
TONEXXNUMBERXXXx
78
l
ll
ll
i
ii
ii
To Next Page
Loading...
