7
Getting started
Install the telephone base and charger, as shown below.
Plug the power adapter into a power outlet not
controlled by a wall switch.
Charger installation
Telephone base installation
Raise the antenna.
Plug the small end of the telephone
base power adapter into the power
adapter jack on the back of the
telephone base.
Route the telephone line
cord through this slot.
Plug one end of the telephone line cord
¼ÁÇ´Ǹ¿¸Ã»ÂÁ¸½´¶¾ÂÅ´¬¥è¿Ç¸Å
Plug the large end of the telephone
base power adapter into a power outlet
not controlled by a wall switch.
If you have DSL
high-speed Internet
ƸÅɼ¶¸´¬¥è¿Ç¸Å
(not included) is
required.
Route the power adapter
cord through these slots.
Plug the other end of the
telephone line cord into the
telephone jack on the back
of the telephone base.
Telephone base and charger installation
To Next Page
Loading...
