AT&T CL83519 - Message playback

85
Answering system
Answering system settings
Call screening
Use this feature to choose whether incoming messages can be heard over the
speaker when they are being recorded. If you turn call screening on, you hear
the incoming message.
To change the setting:
Using a cordless handset or the telephone base:
1. When the handset or telephone base is in idle mode, press MENU/
SELECT to enter
the main menu.
2. Press T
CID or SDIR to scroll to Answering sys, then press MENU/SELECT.
3. Press T
CID or SDIR to scroll to Ans sys setup, then press MENU/SELECT.
4. Press
MENU/SELECT to select Call screening.
5. Press T
CID or SDIR to choose On or Off.
6. Press
MENU/SELECT to save the setting.
Number of rings
²ÂÈ¶´ÁƸÇÇ»¸´ÁÆʸżÁºÆÌÆǸÀÇÂ´ÁÆʸÅ´Á¼Á¶ÂÀ¼Áº¶´¿¿´ì¸ÅÇÊÂǻŸ¸
¹ÂÈÅèɸÂÅƼËżÁºÆ²ÂÈ¶´Á´¿ÆÂƸ¿¸¶ÇÇ¿¿ƴɸÅ¢¹Ç¿¿ƴɸÅ¼ÆƸ¿¸¶Ç¸·Ç»¸
´ÁÆʸżÁºÆÌÆǸÀ´ÁÆʸÅÆ´¶´¿¿´ì¸ÅÇÊÂżÁºÆÊ»¸ÁÌÂÈ»´É¸Á¸ÊÀ¸ÆÆ´º¸Æ
´Á·´ì¸Å¹ÂÈÅżÁºÆÊ»¸ÁÇ»¸Å¸´Å¸ÁÂÁ¸ÊÀ¸ÆÆ´º¸Æ»¼Æ¹¸´ÇÈŸ´¿¿ÂÊÆ
you to check for new messages and avoid paying long distance charges when
calling from out of your local area. By default, the answering system answers an
¼Á¶ÂÀ¼Áº¶´¿¿´ì¸Å¹ÂÈÅżÁºÆ
To set the number of rings:
Using a cordless handset or the telephone base:
1. When the handset or telephone base is in idle mode, press MENU/
SELECT to enter
the main menu.
2. Press T
CID or SDIR to scroll to Answering sys, then press MENU/SELECT.
3. Press T
CID or SDIR to scroll to Ans sys setup, then press MENU/SELECT.
4. Press T
CID or SDIR to scroll to # of rings, then press MENU/SELECT.
5. Press T
CID or SDIR to choose among 2, 3, 4, 5, 6 or Toll saver.
6. Press MENU/SELECT to save the setting.
Note: If Smart call blocker is on, the first ring of all calls will be muted.