80
Answering system settings
Use the answering system menu of a system handset or the telephone base
ÇÂƸÇÈÃÇ»¸´ÁÁÂÈÁ¶¸À¸ÁÇÀ¸ÆÆ´º¸ÇÈÅÁÂÁÂÅÂæÇ»¸´ÁÆʸżÁºÆÌÆǸÀ
or message alert tone, activate call screening, or change the number of rings,
ŸÀÂǸ´¶¶¸Æƶ·¸ÂÅÀ¸ÆÆ´º¸Å¸¶ÂÅ·¼ÁºÇ¼À¸¢¹ÌÂÈÇÈÅÁÂæÇ»¸´ÁÆʸżÁº
system and you change any setting in the answering system setup menu, the
answering machine automatically turns on again.
1. When the device is in idle mode, press MENU/
SELECT to enter the main menu.
2. Press T
CID or SDIR to scroll to Answering sys, then press MENU/SELECT.
Announcement
Your outgoing announcement plays when calls are answered by the answering
system.
The telephone has a default outgoing announcement, “¡¸¿¿Â©¿¸´Æ¸¿¸´É¸´
À¸ÆÆ´º¸´ì¸ÅÇ»¸ÇÂÁ¸” You can use this announcement, or record your own.
You can record an announcement up to 90 seconds. The system does not
record any announcement shorter than two seconds.
To play your current outgoing announcement:
Using a cordless handset:
1. When the handset is in idle mode, press MENU/
SELECT to enter the main
menu.
2. Press T
CID or SDIR to scroll to Answering sys, then press MENU/SELECT.
3. Press
MENU/SELECT again to select Announcement.
4. Press T
CID or SDIR to scroll to Play annc, then press MENU/SELECT.
Using the telephone base:
1. When the telephone base is in idle mode, press MENU/
SELECT to enter the
main menu.
2. Press T
CID or SDIR to scroll to Answering sys, then press MENU/SELECT.
3. Press
MENU/SELECT again to select Announcement.
4. Press T
CID or SDIR to scroll to Play annc, then press MENU/SELECT.
Answering system
To Next Page
Loading...
Need help?
General
