35
Intercom
Using the telephone base:
1. When the telephone base is not in use, press MENU/
SELECT to enter the main
menu. Press T
CID or SDIR to scroll to Intercom, then press MENU/SELECT.
f If you have one handset and no other registered devices, the telephone
base shows Calling HANDSET X.
f If you have cordless headset(s)/speakerphone(s) or more than one
handset, the telephone base shows INTERCOM TO:. Use the dialing keys
to enter a specific handset number (1-9 for handsets 1-9, TONE
followed
by 0-2 for handsets 10-12, # for a single headset/speakerphone, # followed
by 1 or 2 for headset/speakerphone 1 or 2, or TONE
followed by # for all
devices), or press T
CID or SDIR to scroll to the desired device and press
MENU/SELECT. The telephone base shows Calling HANDSET X or Calling
all handsets.
The destination device(s) rings and shows BASE 0 is calling or
BASE 0 is calling all.
2. To answer the intercom call, press
PHONE/FLASH, /SPEAKER or any
dialing key (0-9, TONE
, or
#
) on the destination handset. Both the base and
the handset now show Intercom.
3. To end the intercom call, one party presses
OFF/CANCEL, or places the
handset back in the telephone base or charger; or presses CANCEL on the
telephone base. The other party hears four beeps. Both devices display
Intercom ended.
Notes:
f For cordless headsets and speakerphones, refer to the corresponding user’s manual on how to answer and end an
intercom call.
f If a total of two cordless headset(s) and/or speakerphone(s) are registered to the telephone base, they appear as
HEADSET 1 and HEADSET 2, respectively, in the intercom menu.
Multiple handset use
To Next Page
Loading...
