Syn248 Installation and Configuration Guide Back to Contents
Installation 28
Connecting a Music on Hold Source
Your music on hold (MoH) source can be a streaming audio source, such as a radio or
MP3 music player. The audio source must have a volume control. The volume adjustment
on the audio device should be set to obtain the preferred level of music on hold within
the system.
On-hold music functionality should only be used in conjunction with music
specifically licensed for on-hold use. Licensed on-hold music is available from
many third-party suppliers. AT&T disclaims any liability arising from the failure to
obtain such a license.
When connecting an MoH source, ensure that you use the supplied audio in/out
cable to connect the source to the SB35025 Deskset AUX I/O port.
The supplied audio in/out cable terminates in a tip/sleeve (or ground)
connection at the “Music on Hold Input” jack. Ensure that the cable that
connects between the supplied audio cable and your MoH source is compatible
with this configuration. Either cable connector shown below would be
compatible.
To Next Page
Loading...
