AT&T Syn248 SB35025 - Device Configuration

Syn248 Installation and Configuration Guide Back to Contents
Device Configuration 82
C HAPTER
3
D EVICE C ONFIGURATION
This chapter shows you how to configure the Syn248 system using the device
configuration menus. Most of these functions are duplicated in the WebUI, but if you need
to assign static IP addresses, they must be set at each device. You can only directly reset
a device from the device, although some functions in the WebUI include device resets.
This chapter covers:
 “SB35010 Gateway Features” on page 83
 “Gateway Front Panel Interface” on page 85
 “Deskset Admin Settings” on page 89.