Syn248 Installation and Configuration Guide Back to Contents
Installation 26
Connecting an Overhead Paging System (OHP)
You can connect a single-zone overhead paging system to an SB35025 Deskset using
the supplied audio in/out cable. Syn248 supports one single-zone paging system per
Syn248 system. If necessary, you can connect both an overhead paging system and a
Music on Hold source to a single SB35025 Deskset using the supplied audio in/out cable.
Syn248 supports most OHP systems that support auxiliary audio-out connections to a
PBX. You should also refer to your OHP system's product documentation for installation
and configuration instructions or contact your OHP equipment provider. Some settings
for the OHP may have to be changed to work with Syn248.
A single-zone paging system:
broadcasts to all overhead speakers at once.
can be included in a Syn248 Paging Zone.
does not appear in the Paging Zones menu on a Deskset unless you add
Overhead Page to a paging zone you create.
must be connected to the SB35025 AUX I/O port. You may need to make or buy
a custom cable for the final connection to the paging system. One end of this
cable must have a 1/8-inch (3.5 mm) jack to connect to the supplied audio in/out
cable.
When connecting an overhead paging system, ensure that you use the supplied
audio in/out cable to connect the system to the SB35025 Deskset AUX I/O port.
The supplied audio in/out cable terminates in a ring/sleeve (or ground)
connection at the “Paging Output” jack. Ensure that the cable that connects
between the supplied audio cable and your overhead paging system is
compatible with this configuration. The cable connector shown below would be
compatible.
Whether you are replacing a phone system and using an existing, functional
OHP, or installing a new OHP, the paging system may have settings that need
to be adjusted to work with Syn248.
To Next Page
Loading...
