Syn248 Installation and Configuration Guide Back to Contents
Device Configuration 90
Setting Intercom Call Forward–No Answer
Intercom Call Forward–No Answer is an administrator setting to handle unanswered
intercom calls for each Deskset. Intercom calls include calls from other Desksets and
outside calls that have been routed to a Deskset by a Phone Line Call Forward–No
Answer setting. See “Configuring Phone Line CFNA” on page 53.
By default, intercom calls are forwarded to voicemail after they ring for 15 seconds. You
can change the target destination to another extension or to an outside phone number,
or you can turn off Intercom CFNA entirely. You can adjust the delay from 5 to 45
seconds.
To set up Intercom Call Forward–No Answer:
1. On the Admin Settings menu, press 1 to display the Intercom CFNA settings.
2. Press
or to select a target:
Mailbox.
Ext. Then press and enter a valid extension in the to Ext: field.
Phone #. Then press and enter a valid phone number. Before you can save
this setting, “Fwd/Trans to Outside Line” must be enabled.
OFF. Calls will not be forwarded. Go to Step 5.
3. Press
to highlight the Delay before forwarding.
4. Press
or to adjust the delay time in five-second increments.
5. Press to accept the change and display the Admin Settings menu.
Calls forwarded to outside lines use two telephone lines. You can limit the
duration of calls forwarded to outside lines with the Timer for Forwarded and
Transferred Outside Calls setting. See “Changing the System Basic Settings”
on page 39.
You can also disable Fwd / Trans to Outside Line individually for each
extension. See “Fwd/Trans to Outside Line” on page 91. If Fwd / Trans to
Outside Line is disabled, you cannot change the target destination to an
outside phone number.
Intercom CFNA
Mailbox
Save
Target:
Delay: [15 sec]
Press or to move highlight.
Use or to cycle through options.
Quick
Dial
SB35031 Deskset SB35025/SB35020 Deskset
To Next Page
Loading...
