Syn248 Installation and Configuration Guide Back to Contents
Installation 30
Cordless Headset Installation and Registration
Install the cordless headset charger, then install and charge the battery according to the
headset user’s manual.
You can register one AT&T DECT Cordless Headset to a Deskset. When a Deskset has a
cordless accessory, the Deskset and headset are all part of the same extension, and only
one device can be used at a time.
SB35025 Deskset Registration
To register the cordless headset:
1. On the Deskset, press (MENU), then 2, and then 6.
The Cordless Headset menu appears.
2. Remove and replace the cordless headset from its charging base.
3. Press . Registration in Progress... appears while the Deskset searches
for the headset.
4. When registration is complete, Headset is registered appears.
5. Press (CANCEL). The User Settings menu appears.
The SB35020 Deskset does not support AT&T DECT Cordless Headsets.
The headset must be in the charger, fully charged and deregistered from any
other device before registration can proceed. Remove and replace the cordless
headset before you press on the Deskset.
While registration is in progress, registration can be terminated by pressing
(CANCEL) on the Deskset.
If the cordless headset is registered to another Deskset, it must be
deregistered first. See “Deregistering a Cordless Headset” on page 32.
To Next Page
Loading...
