31
Handset operation
Options while on calls
Hold
Use this feature to hold one line while accessing another, or as part
of the conference and call transfer features.
While on a call, press and release HOLD. The L 1-L 4
indicator for the line on hold flashes slowly on the
screen. After the call has been on hold for more than
three minutes, you will hear a triple beep every
30 seconds. (To adjust the volume of the reminder
tone or turn it off, see Hold reminder on page 17.)
If you are using the speakerphone, thespeakerphone, the, the
speakerphone turns off automatically when you turns off automatically when you
press HOLD.
To release the hold, press the L 1-L 4 key of the
call on hold.
NOTES:
By default, a call on hold after 10 minutes is automatically forwarded to the auto
attendant, even if the auto attendant is not on for that line. If Persistent hold is
enabled on the telephone base, the call will stay on hold until it is released or hung
up. For details, see Persistent hold in the SynJ SB67138/SB67158 telephone base
manual. To keep a call on hold longer than 10 minutes, you can also release the held
call within 10 minutes and then place the call on hold again.
You cannot put an intercom call on hold.
Switching between lines
Use this feature to switch between lines during an outside call:
Press the L 1-L 4 key of another line to make or answer another
call. The current call is put on hold automatically.
To return to the first call, press the original L 1-L 4 key. The second
line is put on hold automatically.
•
•
1.
2.
To Next Page
Loading...
Need help?
General
