AT&T SynJ SB67108 User Manual

23
Getting started
Mailbox setup
Announcement setup
The announcement is the greeting callers hear when calls are
answered by the handset mailbox.
The handset has the default announcement “Hello, please leave a
message after the tone.” You can use this announcement, or replace
it with your own recording.
Your announcement can be up to two minutes.
Play the current personal announcement:
When the handset is idle, press the M.box softkey.
Press DIR or CID to select Anncemnt setup. Press MENU/ENTER
and the current announcement plays.
Press MENU/ENTER or the OK softkey when finished.
Record a new personal announcement:
When the handset is idle, press the M.box softkey.
Press DIR or CID to scroll to Anncemnt setup.
Press MENU/ENTER to play current announcement.
3. Press the Change softkey, and then press the
Start softkey. The system announces, “Record
after the tone. Press Stop when you are done.”
4. Press the Stop softkey when finished. The
recorded announcement plays.
5. Press the OK softkey to use the new recorded
announcement.
-OR-
Press the Change softkey to record the
announcement again.
1.
2.
3.
1.
2.
0 New Messages
Play all
Deliver
>Anncemnt setup
Back
1:Handset 1
11:28AM 03/24
M.box CID
Play anncemnt
00:01
OK Change
Record anncemnt
Back Start

AT&T SynJ SB67108 Specifications

General

Brand	AT&T
Model	SynJ SB67108
Category	Handsets
Language	English