AT&T SynJ SB67108 User Manual

8
Getting started
Add and register handsets
The handset provided with your SynJ SB67138/SB67158 is already
registered as Handset 1. Additional handsets are assigned numbers
in the order they are registered (Handset 2 to Handset 10). You can
register a maximum of 10 handsets.
You can add new handsets (SynJ SB67108, sold separately) to the
SynJ SB67138/SB67158 at any time, but each new handset must be
registered with the telephone base before use. Each handset must
be registered separately.
If the handset does not have enough power to
proceed with the registration, you need to charge
the new handset for at least five minutes (see
page 7). Start registration when the handset screen
shows Press MENU on BS, sel Registration & sel
Register HS. Then put HS in cradle.
To register a handset to your SynJ SB67138/SB67158 telephone base
1. Make sure the handset is out of the charger and the
screen shows Press MENU on BS, sel Registration
& sel Register HS. Then put HS in cradle. before
you begin registration.
2. On the telephone base, press MENU/ENTER.
3. Scroll down to Registration and press MENU/ENTER.
4. Press MENU/ENTER again to select Register HS.
The telephone base screen shows
Registering new device...
5. Place the unregistered handset into the charger.
The handset beeps once and begins registering
to the telephone base. It takes up to 60 seconds
to complete the registration. There is a beep
sound when the registration is successful. The
telephone base shows Handset registered and
then the handset shows X:Handset X (X represents the handset
number [1-0]; Handset X represents the handset name).
Press MENU on BS,
sel Registration
& sel Register
HS. Then put HS
in cradle.
COVM
Speed dial setup
Customer support
Registration
>
Register HS
Deregistration
>
Registering
new device...
Handset
registered

AT&T SynJ SB67108 Specifications

General

Brand	AT&T
Model	SynJ SB67108
Category	Handsets
Language	English