EasyManuals Logo

AT&T SynJ SB67108 User Manual

AT&T SynJ SB67108
103 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #84 background imageLoading...
Page #84 background image
78
Appendix
California Energy Commission battery charging
testing instructions
This telephone is set up to comply with the energy-conserving standards right out
of the box. These instructions are intended for California Energy Commission (CEC)
compliance testing only. When the CEC battery charging testing mode is activated, all
telephone functions on the cordless handsets, except battery charging, will be disabled.
When first purchased and properly installed for charging (see Handset battery
installation and charging on pages 6-7), put the handset in the handset charger to
charge. The CEC battery charging testing mode is activated while charging.
If you have registered the handset to the SynJ SB67138/SB67158 base, below are the
testing instructions.
To activate the CEC battery charging testing mode:
Press MENU/ENTER on the telephone base in idle mode.
Scroll down to Registration and press MENU/ENTER.
Scroll down to Deregistration and press MENU/ENTER.
The telephone base screen shows Deregister:. Scroll to choose ALL, then press
MENU/SELECT.
The telephone base screen shows Deregister All? <=No =>Yes. Press SKIP.
Then, the telephone base shows Deregistering.
The process takes up to 10 seconds to complete. When the phone successfully
enters the CEC battery charging testing mode, the telephone base shows
All devices deregistered. You hear a confirmation tone.
Note: When the phone fails to enter this mode, reset the system and repeat the
steps mentioned above.
To reset the system: pick up the handset and press PHONE/FLASH, then
press OFF/CLEAR and place the handset back into the charger.
You can also reset the telephone base by unplugging the power adapter from the
telephone base and plugging it back in.
To deactivate the CEC battery charging testing mode:
Unplug the telephone base power adapter from the power outlet, then plug it back
in. The telephone base is powered up as normal.
Register the handsets back to the telephone base. See pages 8-9 for handset
registration instructions.
1.
2.
3.
4.
5.
1.
2.
BC

Table of Contents

Other manuals for AT&T SynJ SB67108

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AT&T SynJ SB67108 and is the answer not in the manual?

AT&T SynJ SB67108 Specifications

General IconGeneral
BrandAT&T
ModelSynJ SB67108
CategoryHandsets
LanguageEnglish

Related product manuals