5
Getting started
Handset battery installation and charging
Install the battery, as shown on the next page. Once you have
installed the battery, the screen indicates the battery status (see the
following table). If necessary, place the handset in the charger to
charge the battery. For best performance, keep the handset in the
charger when not in use. The battery is fully charged after 16 hours
of continuous charging. See the table on page 82 for battery
operating times.
If the screen is blank, you need to charge the handset without
interruption for at least 10 minutes to give the handset enough
charge to use the telephone for a short time. The screen flashes
Low battery until you have charged the battery without interruption
for at least one hour. The following table summarizes the battery
charge indicators and actions to take.
Battery indicators Battery status Action
The screen is blank. Battery has no
charge and the
handset cannot be
used.
Charge without
interruption for at
least 10 minutes.
The screen shows
Charging.
The screen shows
Low battery.
flashes, and the
handset beeps.
Battery has enough
charge to be used for
a short time.
Charge without
interruption at least
one hour.
The screen shows
Charge completed.
Battery is fully
charged.
To keep the battery
charged, place it in
the charger when not
in use.
NOTE: In low battery mode, you hear four short beeps per minute.
To Next Page
Loading...
Need help?
General
