10
Getting started
Handset battery installation & charging
Install the battery as shown below. After installing the battery, you can make
and receive short calls, but replace the handset in the charger when the
handset is not being used. For optimal performance, charge the handset
battery for at least 16 hours before use. When fully charged, the handset
battery provides up to approximately eight hours of talk time or four days of
standby time.
Press the tab and
slide the battery
compartment cover
downwards.
Insert the supplied
battery as indicated.
Insert the top (on
contacts and tab) in first,
then push downwards on
the lower portion of the
battery.
Align the cover flat
against the battery
compartment, then
slide it upwards until
it clicks into place.
Step 3
Step 2
Step 1
IMPORTANT INFORMATION
Use only the battery supplied with this product. To order a replacement or spare
battery (AT&T model 102, part number 89-1324-00-00) or equivalent, visit our website
at www.telephones.att.com, or call 1 (800) 222-3111. In Canada, dial
1 (866) 288-4268.
Charge the handset by placing it facing the
front in the charger. The CHARGE light will be
on when the handset is charging.
To Next Page
Loading...
Need help?
General
