Telephone operation
25
Call transfer using intercom
On a cordless handset:
Use the intercom feature to transfer an outside
call to the telephone base or a cordless handset
in the system.
While on an outside call, press
/X-FER/INTERCOM on the handset.
Press the or softkey to choose the desired
handset and press the OK softkey, or enter
the handset number (e.g. 1 for handset 1). The
called handset will ring, and its screen will
show TRANSFER FROM HANDSET X.
-OR-
Press the or softkey to choose BASE and
press the OK softkey, or enterenter 0 to transfer
the outside call to the telephone base. The
telephone base will ring, and its screen will
show TRANSFER FROM HANDSET X.
3. On the ringing handset, press LINE 1/FLASH or
LINE 2/FLASH, /X-FER/INTERCOM or
SPEAKER to answer the transferred call.
-OR-
On the ringing telephone base, press
/INTERCOMINTERCOM/TRANSFER or SPEAKER, or lift
the corded handset to answer the transferred
call.
If you want to intercom the desired handset
or telephone base before the outside call is
transferred, press the HOLD softkey to put the
outside call on hold and follow the steps for
Intercom on page 22. At the end of the intercom
call, resume the outside call by pressing the
corresponding line button and follow the steps
on this page to transfer the call.
1.
2.
NOTES:
1. If the called handset or
telephone base does not
answer within 30 seconds,
the outside call returns to
the calling handset and is
put on hold. If the held call
is not resumed within five
minutes, the calling handset
rings and its screen displays
CALL ON HOLD RING
BACK! If the held call is not
resumed within 30 seconds,
the call is disconnected.
2. Pressing OFF/CLEAR on
the handset or CLEAR on
the telephone base will
temporarily silence the
intercom ringer.
To Next Page
Loading...
Need help?
General
