6
Getting started
IMPORTANT INFORMATION
1. Use only the power adapters supplied with this product or equivalent. To order a replacement
power adapter, visit our website at www.telephones.att.com, or call
1 (800) 222-3111. In Canada, dial 1 (866) 288-4268.
2. These power adapters are intended to be correctly oriented in a vertical or floor mount position.
The prongs are not designed to hold the plug in place if it is plugged into a ceiling, under-the-
table or cabinet outlet.
Telephone base installation (2-line jack)
If you subscribe to high-speed Internet service (Digital Subscriber Line - DSL)
through your telephone lines, you must install a DSL filter between the
telephone base and the telephone wall jack. The filter will prevent noise
and caller ID problems caused by DSL interference. Please contact your DSL
service provider for more information about DSL filters.
The telephone line cord can be plugged into LINE 1/L1+L2 or LINE 2
telephone jack in the telephone base. However, it is suggested to plug the
telephone line cord with two telephone numbers into the LINE 1/L1+L2
telephone jack if you intend to connect the telephone to a fax machine or
modem through the DATA port.
If you have a 2-line wall jack, install the telephone base as shown below.
Telephone base installation
1. Plug the small end
of the telephone
base power adapter
into the power jack
at the bottom of the
telephone base.
3. Plug one end of the
telephone line cord into the
LINE 1/L1+L2 telephone
jack at the bottom of the
telephone base.
5. Plug the other
end of the coiled
handset cord into
the jack at the
bottom of the
telephone base
and route the cord
through the slots.
Line 1+Line 2
2. Plug the telephone
base power adapter
into an electrical
outlet not controlled
by a wall switch.
4. Plug the other
end of the
telephone line
cord into a 2 line
telephone jack.
Telephone
line cord
DSL filter (not included,
required for DSL users).
To Next Page
Loading...
Need help?
General
