13
Getting started
Belt clip & optional headset
Installation
Snap the belt clip
into the retaining
tabs on both sides
of the handset as
shown in the
figure.
Removal
Gently lift either of the belt
clip retaining tabs, shown
in the figure, outwards to
remove the belt clip from the
handset.
For handsfree telephone conversations, you can use any industry standard
2.5 mm headset (purchased separately). For best result, use an AT&T 2.5 mm
headset. To purchase a headset, visit our website atvisit our website at
www.telephones.att.com
or call
1 (800) 222-3111.
In Canada, dial
1 (866) 288-4268.
Lift the rubber
flap here.
Left side of handset
Press to switch
to headset.
Plug a 2.5 mm headset
into the jack on the side
of the handset (beneath
the small rubber flap).
To Next Page
Loading...
Need help?
General
