Atlas Copco FlexiROC T20 R - Before Starting; Safety; Checks

24
Operator's instructions
3. Daily checks
Before starting
Safety
• Danger of moving parts
• Can cause serious injuries
• Set all levers and switches in NEUTRAL
position before startup preparations
• Carry out the procedures with the engine
switched off
• Dangerous compressed air
• Can cause serious injury
• Release the pressure in the tank before
removing the filler plug
Checks
Table: Checks before starting.
Check point Inspection Instructions
Drill rig. Visual check Make sure there are no signs
of leaks, damage, breakage
or cracks.
Hydraulic oil Oil level Check oil level. Top up as
necessary.
Lubrication oil Oil level Check oil level. Top up as
necessary.
Motor oil Oil level Check oil level. Top up as
necessary.
Compressor oil Oil level Check oil level. Top up as
necessary.
Water separator Fuel prefilter Drain off the water
For further instructions, see: Maintenance instructions