97
Operator's instructions
7. Drilling
Sliding off and picking from the control panel
Figure: Control panel
1. Check that the joint is detached.
2. Open the drilling rod support. Selector R10 on C and multi-function lever R13 in position
D
3. Raise the drilling battery until the sleeve reaches the drilling rod support. Selector R10 on
C and multi-function lever R15 in position C
4. Close the upper drilling rod support. Selector R10 on C and multi-function lever R13 in
position E
5. Activate sliding off by bringing multi-function lever R14 in position C
6. Slide the grip off of the drilling rod.
To Next Page
Loading...
