Atlas Copco FlexiROC T20 R - Function Test While Drilling; Checks

26
Operator's instructions
3. Daily checks
Function test while drilling
Checks
Table: Checks during drilling
Check point Inspection Instructions
Rock drill
hydraulic hoses
Abnormal vibration Check the accumulators, for further instructions see
"Maintenance instructions for rock drill".
Rock drill Shank adapter Make sure that oil trickles out between the front and the
shank adapter.
Indicator lamps Diesel panel Make sure no faults are indicated. If a fault indication is
shown, stop the drill rig and rectify the fault.
Dust collector
(DCT)
Suction ability and
filter cleaning
Check the filter in the filter holder and suction hose and
also the drill-steel support's drill gasket.
Drill rig
Complete drill rig
Check for signs of leaks.
Pressure gauge
Pressure gauge
panel
Check all the pressure gauges to see that the
hydraulic pressure is normal. Call for a service
technician if there are any deviations.
For further instructions, see: Maintenance instructions