Atlas Copco FlexiROC T20 R - Page 30

30
Operator's instructions
4. Controls
R05
Mode selector
a) Stabilizers (orange)
b) Neutral position
c) Positioning (yellow)
R06
Mode selector
a) Vehicle (blue)
b) Neutral position
c) Positioning (violet)
R07
Winch selector
a) winch in manual
b) winch off
c) winch in automatic
R08
Winch pulling force selector
a) high
b) medium
c) low
R09
Extractor/pump water flush selector (option)
a) Water flush active
b) Extractor active
c) Extractor/Water flush inactive
R10
Mode selector
a) manual drilling
b) Neutral position
c) Change rods (green)
R11
Selector for option
R12
Button emergency stop