Atlas Copco FlexiROC T20 R - Page 39

39
Operator's instructions
4. Controls
Figure: Slide carriage positioning mode screen
Key 1 Arm Raising/Lowering – Retraction/ Extension
Key pressed and multi-function lever P01 on A Lower arm
Key pressed and multi-function lever P01 on B Raise arm
Key pressed and multi-function lever P01 on C Retract arm
Key pressed and multi-function lever P01 on D Extend arm
Key 2 Arm rotation – Drilling slide rotation
Key pressed and multi-function lever P01 on A Slide left rotation
Key pressed and multi-function lever P01 on B Slide right rotation
Key pressed and multi-function lever P01 on C Arm left rotation
Key pressed and multi-function lever P01 on D Arm right rotation
Key 3 Slide inclination
Key pressed and multi-function lever P01 on A Slide backwards inclination
Key pressed and multi-function lever P01 on B Slide forwards inclination
Key pressed and multi-function lever P01 on C Slide left inclination
Key pressed and multi-function lever P01 on D Slide right inclination
Key 4 Raise/Lower Drill
Key pressed and multi-function lever P01 on A Lower drill
Key pressed and multi-function lever P01 on B Raise drill
Key 5 Raise/Lower slide - Drilling rod support
Key pressed and multi-function lever P01 on A Lower slide
Key pressed and multi-function lever P01 on B Raise slide