Atlas Copco GA 5

Digital input
screens
Designation Related topic
<d.4> Loading hours (hrs or x1000 hrs) See section Calling up loading hours
<d.5> Load relay (x1 or x 1000) See section Calling up Calling up load relay
<d.6> Service timer reading (hrs or x 1000 hrs) See section Calling up/resetting the service
timer
<d.7> Actual program version
Parameter
screens
Designation Related topic
<P.01> Selection between local, remote or LAN
control
See section Selection between Local
Remote and LAN control
<P.02> Setting a node ID for LAN control and the
channels for Mk 4 and Mk 5
See section Calling up/modifying CAN
address control
<P.03> Settings for IP, gateway and Subnet mask See section Calling up/modifying IP,
Gateway and Subnetmask
<P.04> Pressure band settings See section Calling up/modifying pressure
band settings
<P.05> Setting a pressure band selection See section Modifying pressure band
selection
<P.06> Modifying a service timer See section Calling up/modifying service
timer settings
<P.07> Setting of unit for temperature See section Calling up/modifying unit of
temperature
<P.08> Setting of unit for pressure See section Calling up/modifying unit of
pressure
<P.09> Selection for function: Automatic restart after
voltage failure (active or not, only for Atlas
Copco)
See section Activating automatic restart
<P.10> Selection between Y-D or DOL starting See section Selection between Y-D or DOL
starting
<P.11> Setting of load delay time See section Calling up/modifying load delay
time
<P.12> Setting of minimum stop time See section Calling up/Modifying minimum
stop time
<P.13> Setting a password See section Activating password protection
<P.14> Remote pressure sensing See section Activate Load/Unload remote
sensing
Protections
screens
Designation Related topic
<Pr.01>
<Pr.02>
<Pr.03>
Protections screens See section Calling up/modifying protection
settings
Instruction book
36 2920 7090 51