Atlas Copco GA 5 User Manual

• This parameter can only be modified after entering a code. Consult Atlas Copco if the parameter is to be
changed.
3.26 Calling up modifying load delay time
Control panel
Starting from the Main screen:
• Press Scroll button (12) until <P.11> and the compressor load pictograph is shown and press the Enter
button (13):
• This screen shows the load delay time 10 and the unit <s> seconds. To modify this value press the Enter
button (13) (a password may be required).
• The value starts blinking and Scroll buttons (12) can be used to modify the value.
• Press the Enter button (13) to program the new value.
The minimum and maximum value depends on the parameters.
3.27 Calling up modifying minimum stop time
Starting from the Main screen:
Instruction book
2920 7090 51 51

Atlas Copco GA 5 Specifications

General

Model	GA 5
Category	Air Compressor
Power	5.5 kW
Noise Level	68 dB(A)
Cooling System	Air-cooled
Drive Type	Direct Drive
Maximum Working Pressure	10 bar
Capacity FAD	0.45 m³/min
FAD Capacity	0.45 m³/min
Free Air Delivery	0.45 m³/min