Atlas Copco GA 75+ - IP, Gateway, and Subnetmask Settings

Press the Enter button (13) to modify the setting. The utmost left value will blink. Change this value by using
the Scroll buttons (12). Press the Enter button (13) to confirm. Change the other values in the same way, as
required.
After modifying the settings, the screen may look as follows:
3.18 Calling up/modifying IP, Gateway and Subnetmask
Calling up
Starting from the Main screen, press the Scroll button (12) until <P. 3> is shown and then press Enter button
(13).
The next screen shows either <OFF> or <On>. If <On>, press the Enter button (13) to modify it to <OFF>.
Use the Scroll buttons Up or Down (12) to scroll between the items in this list (<IP> for IP address, <Sub>
for Subnetmask or <GAtE> for Gateway):
Instruction book
2920 7109 60 45