Unloading pressure
• Press Enter button (13) to modify the load level (value starts blinking). A password may be required. Use
Scroll buttons (12) to change the loading pressure.
• Press Enter button (13) to program the new values or press the Escape button (14) to cancel.
3.20 Modifying the pressure band selection
Control panel
Starting from the Main screen:
•
Press
Scroll button
(12)
until <P.05>
is
shown and
then
press Enter
button
(13). The
active
pressure band
1 (<Pb.1>) is shown on the display.
• Press Enter button (13) to modify the pressure band selection (a password may be required). The active
pressure band <Pb.1> starts blinking.
• Press button (12) to modify the active pressure band. Press Enter button (13) to confirm or the Escape
button (14) to cancel.
Instruction book
48 2920 7109 60
To Next Page
Loading...
