- 46 -
Notes:
(1) More frequently when operating in a dusty
environment.
(2) Refer to engine operation manual.
(3) After each day of work.
(4) Yearly is only valid when using PARCOOL/
GENCOOL. Change coolant every 5 years.
(5) Gummed or clogged filters will lead to fuel
starvation and reduced engine performance.
Reduce service interval in heavy duty
application.
(6) See section oil specification.
(7) The following part numbers can be ordered from
Atlas Copco to check on inhibitors and freezing
points:
2913 0028 00 refractometer
2913 0029 00 pH meter.
(8) See also chapter “Before starting”.
(9) Replace all rubber flexibles every 5 years.
(10)See section “Battery care”.
(11)See section “Measuring the alternator insulation
resistance”.
(12)See section “Critical bolt connections”.
(13)The function of this protection should be tested
minimum on every new installation.
(14)Water in fuel tank can be detected by means of
2914 8700 00. Drain fuel tank when water is
detected.
(15)See chapter “Testing engine protections” in the
Engine Operation Manual.
(16)For other specific engine and alternator
requirements, refer to their manuals.
5.1.1 Precautions
– Before proceeding with any type of maintenance,
please take all the necessary precautions to avoid
accidentally starting the engine: disconnect the
battery and switch off the control module.
– Do not carry out any change or modification to
any part of the light tower or its electric system.
– Do not carry out any maintenance when the
engine is running.
– Be careful when close to any moving parts (e.g.
pulleys, fans …) and to any hot parts (e.g. muffler,
engine block, coolants, lubricants …).
5.1.2 Use of maintenance schedule
Regular maintenance is essential for the optimum
performance, safe operation and a longer working life
of the machine.
The maintenance schedule contains a summary of the
maintenance instructions. Read the respective section
before taking maintenance measures.
When servicing, replace all disengaged packing, e.g.
gaskets, O-rings, washers.
For engine maintenance refer to the chapter
“Maintenance schedule” and the Engine Operation
Manual.
The maintenance schedule has to be considered as a
guideline for units operating in a dusty environment
typical to light tower applications. The maintenance
schedule can be adapted depending on application,
environment and quality of maintenance.
5.1.3 Use of service packs
Service packs include all genuine parts needed for
normal maintenance of both light tower and engine.
Service packs minimize downtime and keep your
maintenance budget low.
The order number of the service packs are listed in the
Atlas Copco Parts list (ASL). Order service packs at
your local Atlas Copco dealer.
00_00_HiLight H6+_EN.book Page 46 Friday, June 4, 2021 11:52 AM
To Next Page
Loading...
Need help?
General
