EasyManua.ls Logo

Atlas Copco SF 2+ - Safety Precautions; Safety Icons; General Safety Precautions

Atlas Copco SF 2+
90 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1 Safety precautions
1.1 Safety icons
Danger: Indicates an imminently hazardous situation which, if not avoided,
will result in
death or serious injury.
Warning: Indicates a potentially hazardous situation which, if not avoided, could result in
death or serious injury.
Notice: Indicates a potential situation which, if not avoided, might result in property damage
or in an undesirable result or state.
Note: Indicates important information.
1.2 General safety precautions
The operator must employ safe working practices and observe all related work safety
requirements and regulations.
If any of the following statements does not comply with the applicable legislation, the stricter of
the two shall apply.
Installation, operation, maintenance and repair work must only be performed by authorized,
trained, specialized personnel. The personnel should apply safe working practices by use of
personal protection equipment, appropriate tools and defined procedures.
The compressor is not considered capable of producing air of breathing quality. For air of
breathing quality, the compressed air must be adequately purified according to the applicable
legislation and standards.
Before any maintenance, repair work, adjustment or any other non-routine checks, switch the
controller in service mode (see section Service mode), stop the compressor, press the
emergency stop button, switch off the voltage and depressurize the compressor. In addition, the
power isolating switch must be opened and locked. The process of locking, tagging and trying
to turn on the equipment to confirm it cannot operate is called Lock Out, Tag Out (LOTO).
On units powered by a frequency converter, wait 10 minutes after switching off the voltage,
before starting any electrical repair.
Warning: In a domestic environment, this product may cause radio interference, in which
case supplementary mitigation measures are required.
Danger: If the machine is equipped with an automatic restart after voltage failure
function and if this function is active, be aware that the machine will restart automatically
when the power is restored if it was running when the power was interrupted!
Never play with compressed air. Do not apply the air to your skin or direct an air stream at
people. Never use the air to clean dirt from your clothes. When using the air to clean
equipment, do so with extreme caution and wear eye protection.
The owner is responsible for maintaining the unit in safe operating condition. Parts and
accessories shall be replaced if unsuitable for safe operation.
It is not allowed to walk or stand on the unit or on its components.
Instruction book
2920 7219 10 5

Table of Contents

Related product manuals