EasyManua.ls Logo

Atom Infa Warmer i - Page 14

Atom Infa Warmer i
73 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
WARRANTIES
This equipment is guaranteed by Atom Medical Corporation to be free of any defects in both materials and work-
manship for a period of one year from the date of delivery when used normally for its intended purpose. Any part
of this equipment proving to be defective will be repaired or replaced at no charge during the warranty period. In
the following cases, however, actual expenses need to be paid even during the warranty period.
Wear and tear of expendables(1)
Trouble and damage due to improper handling, such as dropping the unit during transport or transfer(2)
Trouble and damage due to a re, salt, gas, extraordinary voltage, earthquake, lightning, storm and ood, (3)
or other natural calamities.
Travel expenses in the case of a trip to an isolated island, a remote place, etc. for the purpose of repair(4)
Any damage incurred in transit should be reported promptly to Atom accompanied by the certificate of the car-
rier concerned.
All correspondence concerning the equipment should specify the model name and the serial number.
Atom is by no means held responsible for compensation for death, injury or damage to property if such loss
should occur due to any of the following causes.
1. Trouble or damage due to installation, relocation, maintenance or repair by someone other than:
technical personnel employed by Atom•
a sales representative of Atom•
an installation company authorized by Atom.•
2. Trouble or damage to Atom products caused by a product of another company that is not supplied by
Atom.
3. Trouble or damage due to modification, maintenance or repair using a part other than that specified by
Atom.
4. Trouble or damage due to neglecting the operating precautions or operating instructions described in
the Operation Manual of the unit.
5. Trouble or damage due to operation under ambient conditions, including electrical requirements and
installation requirements, other than those described in the Operation Manual.
6. Trouble due to carelessness or improper modification.
7. Trouble or damage due to using a device sold or repaired by a secondhand goods dealer or a repair shop
without notifying Atom. Trouble or damage due to using a device sold or repaired by the above dealer or
shop without following the instructions specified by Atom.
8. Trouble or damage due to using the unit connected to a peripheral device which is not specified by Atom,
which does not meet the applicable requirements of IEC-60601-1 and IEC-60601-1-1, or which is not
equipped with equivalent safety features.
WARNING

Table of Contents

Related product manuals